Spiral chute construction plan

Spiral chute construction plan 1: Introduction: The chute selection includes the inclined flow sorting process. Mineral mortar is fed to a partially inclined chute or inclined surface. Under the driving force of water flow, the mineral particle group is loose and layered, and the lighter minerals in the upper layer quickly flow out of the groove. The heavier minerals in the lower part either stagnate inside the groove or are discharged from the lower part at a low speed. After obtaining the difference, concentrate and tailings are obtained. The fiberglass spiral chute is a machine for mining and beneficiation, especially ideal for sand mining on coasts, riverbanks, sandbanks, and river beds. The equipment has the characteristics of correct structure, simple installation, small land occupation, simple operation, stable beneficiation, clear screening of minerals, large processing capacity, high efficiency, high beneficiation concentration ratio, high recovery probability, and stable operation. There are also advantages such as lightweight, moisture prevention, rust prevention, corrosion resistance, and strong applicability to fluctuations in ore feed volume, concentration, particle size, and grade. 2、 Working principle: The fiberglass spiral chute concentrator does not need to be restricted from being placed on the cross (or tripod) of the support table. The same mineral mortar is slowly fed onto the surface of the rotating groove through the feeding chute installed at the head of the spiral groove for sorting. A valve type equipment is installed at the tail to obtain a slot, allowing the selected products to be divided into three categories (or four categories) according to grade along the radial direction. Change the selection width of each device by adjusting the orientation of the valve block. The product gathering bucket is a concentric circular tube that differentially merges and leads out the intercepted multi-directional mineral flow. The transverse plane and slope of the curve of the spiral concentrator are particularly suitable for the separation of fine-grained materials. Spiral chute construction scheme III. Special features 1. Stable separation process and simple control 2. Large allowable variation range of ore feed concentration 3. High enrichment ratio and high recovery probability 4. Small area occupied, low water consumption 5. Simple structure, no power required 6. Large processing capacity 7. Simple installation and easy operation 8. Small investment, quick results. Spiral chute construction scheme IV The structure of the spiral concentrator consists of a feeding equalizer, a cross (tripod), a feeding chute, a rotating groove, a selection groove, a gathering bucket, and a groove support. 5、 Use This machine is suitable for separating small materials with a particle size of 0.3-0.02mm to obtain iron ore, ilmenite, Chromite, pyrite, zircon, Rutile ore, monazite ore, phosphorus, tungsten ore, tin ore, tantalum niobium ore, tantalum niobium ore and other non-ferrous metal ores, rare mineral metals and non-metallic mineral bodies with gravity differences. Spiral Chute Construction Plan Spiral Chute Construction Plan