How to cut the spiral chute

How to cut the material in a spiral chute? 1. Explain that the chute sorting of minerals includes an inclined flow sorting process. The slurry is fed to a inclined chute or slope, and under the push of water flow, the ore particles are loose and layered. The upper layer is so light that the minerals are quickly discharged to the outside of the chute, while the lower part, which is heavier than the main minerals, stagnates in the inner groove or slowly discharges from the lower part. After being obtained, the concentrate and tailings can be obtained. The spiral concentrator is a machine for mining and beneficiation, especially ideal for mineral mining on coasts, riverbanks, sandbanks, and river beds. The product has the characteristics of reasonable structure, simple installation, small footprint, simple operability, stable beneficiation, clear screening of minerals, strong processing capacity, high efficiency, ultra-high enrichment ratio, high recovery rate, and stable operation. There are also advantages such as lightweight, moisture prevention, rust prevention, corrosion prevention, and strong applicability to fluctuations in ore feed volume, concentration, particle size, and grade. 2、 Use the method to erect the spiral chute, calibrate the vertical line, fix the iron frame or wood in the proper position, and let the mineral sand be sent to the two ore feeding ports above the spiral by the mortar pump, participate in water filling, adjust the density of the mineral sand slurry, and the mineral slurry naturally swirls from top to bottom, generating a single coherent centrifugal force in the rotating slope flow speed, which is distinguished by the specific gravity, Granularity and state of the placer, By separating the ore and sand through the gravity of the swirling flow and the effect of this centrifugal force, the selected ore flows into the concentrate hopper and is piped out. The tailings are discharged into the tailings hopper and moved to the sand tank through a pipeline, and then discharged by a slurry pump, completing the entire beneficiation process. How to cut the spiral chute. 3. Characteristics or advantages. 1. It is of great importance and has strong processing capacity. Today's mineral aggregate processing is objectively conditional on using large scale to create revenue. 2. Fine granulation: for the treatment of fine and micro particle minerals, especially the treatment of ore materials with Granularity of -0.047MM, the original equipment can basically ensure the recovery of+0.047mm particle size. 3. With the development of Hydraulics, two-phase flow and machine vibration, the spiral concentrator has developed from a simple use of gravity and water resistance to a composite application of centrifugal force, equipment vibration force, magnetic separation force, etc. By using a composite force field, more useful minerals are enriched and the separation of fine particles from these fine particles increases the ore recovery rate. 4. Based on energy saving, environmental protection and consumption reduction, the area and space occupied should be small, and the water and electricity consumption should be small. 5. The operation is simple and flexible, the sorting process is stable, the structure is simple and simple, and it is convenient for maintenance management. How to cut the spiral chute? 4. According to the particle size of the processed mineral materials, the chute can be divided into three types: (1) coarse chute. The maximum Granularity of ore feeding is more than 2-3 mm, and the maximum can be 100-200 mm. (2) The ore chute handles 2-3 millimeter sized ores. (3) Slurry spiral chute, feeding particle size ＜ 0.074mm. 5、 The use of fiberglass chutes in the field is suitable for processing 0.6-0.03MM and vein ores as well as minerals, but it is unfavorable for sorting when the mud content is high. It is now widely used for processing iron ore, tungsten, sand tin, tantalum niobium ore, bay and riverbed ore sand or placer gold, and so on. How to cut the material with a spiral chute How to cut the material with a spiral chute